Publicidad
Idiomas disponibles
Idiomas disponibles
2. Fold up the dust bag (special acces-
sories).
Illustration G
3. Close the dust bag (special acces-
sory) tightly with a cable tie under-
neath the opening.
4. Take out the dust bag (special ac-
cessories).
5. Fit and lock the suction head.
Draining the waste water
NT 50/1 only:
1. Drain the waste water via the drain
hose.
Illustration H
General
● We recommend switching off the
"Automatic filter dedusting" function
when vacuuming wet dirt with the
crevice nozzle or the upholstery
nozzle (optional), or when sucking
mainly water out of a container.
● The device switches off automatical-
ly when the maximum fluid level is
reached.
● When vacuuming non-conductive
liquids (e.g. drill emulsion, oils and
grease) the device does not auto-
matically switch off when the con-
tainer is full. The filling level must be
continuously monitored and the con-
tainer emptied on a timely basis.
● On completion of wet vacuum clean-
ing: Clean the flat fold filter using the
dedusting function. Clean the elec-
trodes with a brush. Clean the con-
tainer with a moist cloth and dry it
off.
Clip connection
The suction hose is equipped with a
clip system. All accessory parts with a
nominal width of 1.38 in (35 mm) can
be connected.
Illustration I
Device OFF
Device ON
Automatic filter dedusting:
OFF
Device ON
Automatic filter dedusting:
maximum interval
Device ON
Automatic filter dedusting:
minimum interval
Switching on the device
1. Connect the mains plug.
2. Set the turn switch to the desired
program.
Adjusting the suction power
Only for devices with a built-in sock-
et:
1. Adjust the suction power (min-max)
via the rotary control.
Working with power tools
Only for devices with a built-in sock-
et:
DANGER
Danger of electric shock
Risk of injury and damage.
The socket is only intended for direct
connection of power tools to the vacu-
um cleaner. Any other use of the sock-
et is prohibited.
1. Plug the mains plug of the power
tool into the power socket on the
vacuum cleaner. The vacuum clean-
er is in Standby mode.
2. Switch on the device at the turn
switch.
Note
The vacuum cleaner is automatically
switched on and off with the power tool.
English
Operation
Turn switch
11
Publicidad
