Pedals
Tool
Wheel reflector
Reflector clip
Tail light
12. When installing the pedals, pay attentionto the port of the pedal shaft. The pedal with "L"
stamp is the left pedal, the stamp with "R" is the right pedal, and the right pedal is installed
on the side of the sprocket.
Note: The left pedal is tightened to the left, and the right pedal is tightened to the right.
13. Install the tail light : first connect the control wire of the tail light to the tail light, and then fix the
tail light to the rear hanger with screws.
Accessories list, as shown above.
EN
Charger
Charger cable
Shaft protection cap
Display
Display Pipe Clamp Gasket
Front wheel quick release
06