Publicidad
Idiomas disponibles
Idiomas disponibles
Twist the white wires from both sensors together and
insert them into the left terminal marked with W.
For alignment instructions, see Aligning The Safety
Sensors later in this section.
Tab
Wire Terminal
(Safety Sensor)
"W"
INSTALLING THE INDOOR KEYPAD
See Figure 57.
Install the indoor keypad according to the instructions
included in the keypad operator's manual.
Locate the Entrapment Label.
WARNING:
Do not use garage door opener if keypads or remotes
do not start and stop the motor. An opener that cannot
be controlled with a keypad or remote is dangerous,
can result in death or serious personal injury, and must
be repaired.
INSTALLATION
Wires
(Striped)
Wires
(White)
"G"
Fig. 56
WARNING:
Make sure the keypad is mounted high enough to prevent
unauthorized activation of the garage door opener. It
should be placed at least five feet above the floor so that
it is inaccessible to children. Unauthorized activation of
the opener can result in death or serious personal injury.
WARNING:
Do not start or stop the garage door opener if there is a
person or object in the path of the door, the door has not
been properly balanced, or if you cannot see the doorway.
Failure to follow these instructions can result in death or
serious personal injury.
WARNING:
Entrapment warning label contains important safety
information. Install entrapment warning label next to the
indoor keypad in a prominent location. Use insulated
staples or other mechanical means if the label will not
adhere to the wall.
For details about using the indoor keypad, see Using the
Indoor Keypad in the Operations section.
Entrapment
Label
32 - English
Fig. 57
Publicidad
