Publicidad
Idiomas disponibles
Idiomas disponibles
PROBLEM
When programming the outdoor
keypad, a buzzer sounds and all
console buttons blink seven times.
When programming a car remote,
a buzzer sounds and all console
buttons blink seven times.
During operation, the opener
struggles to raise or lower the door
and then stops. A buzzer sounds
continuously and the SET button
in the console blinks continuously.
When a car remote, smart phone,
or keypad is used a buzzer sounds
and the UP and DOWN buttons
in the console blink continuously
Garage door begins to close then
stops and reverses. A buzzer
sounds five times and the garage
door opener's LED lights blink
five times
Garage door opener is in the fully
open position and cannot be
closed with a car remote, smart
phone, or keypad
Garage door opener does not
activate when indoor keypad is
pressed
Garage door opener activates, but
the garage door does not move
TROUBLESHOOTING
POSSIBLE CAUSE
A step for programming the outdoor
keypad was not completed within
two minutes.
A step for programming the car
remote was not completed within
two minutes.
Motor amperage has exceeded
8 amps.
Door spring (torsion spring and/or
extension spring) is damaged.
Door is too heavy, broken, or
stuck.
The travel limits have been erased
or have not been set correctly.
The garage door opener hit an
object while it was closing.
The safety sensors are not
receiving power.
Keypad's battery is low in charge
or garage door opener is not
connected to power supply
Circuit breaker is tripped
The outer trolley is not engaged with
the inner trolley
The door arms are not connected
to the outer trolley
The door arms are not connected
to the garage door
51 - English
SOLUTION
Complete each step for programming the
outdoor keypad within two minutes.
Complete each step for programming the
car remote within two minutes.
Unplug the unit. Have door spring or door
repaired or replaced by a qualified service
technician.
Unplug the unit. Have door spring repaired
or replaced by a qualified service technician.
Unplug the unit. Have door repaired or
replaced by a qualified service technician.
Set the travel limits as described in the
Installation section.
Remove the object and continue operation.
Inspect sensor wires for damage and
ensure they are installed correctly. Reset
travel limits.
Replace the keypad's battery or connect the
garage door opener to an AC power supply.
Reset circuit breaker
Pull the emergency release rope and raise
the garage door until the outer trolley
engages the inner trolley
Secure the door arms to the outer trolley
using clevis and hitch pin
Secure the door arms to the garage door
using clevis and hitch pin
Publicidad
