Publicidad
EN
5. Do not start the BACK-UP function if there is no battery in the PV system. The manufacturer
shall not be liable for the risks caused by not following this rule.
6. All labels and warning marks should be visible after the installation. Do not scrawl, damage,
or cover any label on the device.
7. Warning labels on the inverter are as follows.
HIGH VOLTAGE HAZARD.
Disconnect all incoming power
and turn off the product before
working on it.
Read through the guide before
working on this device.
High-temperature hazard. Do
not touch the product under
operation to avoid being burnt.
CSA marking for the United
States of America and Canada.
300612
Type 1 Arc-Fault Circuit
PV
AFCI
interrupter in PV side.
Type 1
Battery safety:
1. The battery used with the inverter shall be approved by the inverter manufacturer. The
approved battery list can be obtained through the official website.
2. Before installations, read through the corresponding battery's User Manual to learn about
the product and the precautions. Strictly follow its requirements.
3. If the battery discharged completely, please charge it in strict accordance with the
corresponding model's User Manual.
4. The battery current may be influenced by temperature, humidity, weather condition, etc.,
which may limit the current and affect the laod capacity.
5. If the battery cannot start properly, contact the After-sales Service as soon as possible.
Otherwise, the battery will be damaged permanently.
6. Measure the DC cable using the multimeter to avoid reverse polarity connection. Also, the
voltage should be under the permissible range.
7. To avoid damage the inverter, do not connect one battery pack to multi inverters.
Delayed discharge. Wait 5 minutes
after power off until the components
are completely discharged.
5min
Potential risks exist. Wear proper
PPE before any operations.
Grounding point. Indicates the
position for connecting the PE cable.
Do not dispose of the inverter
as household waste.Discard the
product in compliance with local
laws and regulations, or send it back
to the manufacturer.
02
Publicidad
