Publicidad
Idiomas disponibles
Idiomas disponibles
Chute
If the chute fails to remain stationary during operation, the pre-load of the chute
can be adjusted by tightening the hex nut found on the front of the chute control
head.
1.
To increase the preload, tighten the hex nut clockwise in ¼ turn intervals.
See Figure 31.
2.
If the chute directional control is difficult to crank, decrease the preload by
loosening the hex nut counterclockwise in ¼ turn intervals.
Auger Control
Refer to the Assembly section for instructions on adjusting the auger control cable.
Skid Shoes
Refer to the Assembly section for instructions on adjusting the skid shoes.
Continuous Tracks
The snow blower is equipped with an auto-tensioner on both the left and right
sides. The system is designed to maintain constant tension on both tracks.
However, if the snow blower fails to propel itself because the track wheel is
"jumping" drive lugs, the tracks are too loose and are in need of adjustment. See an
authorized Service Dealer to have the tracks properly adjusted. See Figure 32.
Track Wheel
SERVICE AND MAINTENANCE
Figure 31
Auto-tensioner
Drive Lugs
Figure 32
Belt Replacement
Auger Belt
To remove and replace your snow blower's auger belt, proceed as follows:
1.
To prevent spillage, remove all fuel from tank by running engine until it
stops.
2.
Remove the plastic belt cover on the front of the engine by removing the two
self-tapping screws. See Figure 33.
3.
Roll the auger belt off the engine pulley. See Figure 34.
23
Figure 33
Figure 34
Publicidad
