Publicidad
Idiomas disponibles
Idiomas disponibles
INT
MISTRAL S
Height-Adjustable, Foldable Handle
Swivelling the Foldable Handle
Parking brake
Applying the parking brake (Fig.1)
Move brake lever 1 in the direction of the arrow until the
safety lever 2 audibly clicks into place; the parking brake
is on.
Releasing the parking brake (Fig.2)
Press the safety lever 2 and move brake lever 1 in the di-
rection of the arrow as far as it will go; the parking brake
is released.
Tip: If the parking brake cannot be operated easily, push
the pram a few centimetres forwards or backwards so
that the brake rods grip the rims correctly. Each time you
apply the brake, make sure that the brake has locked
completely and that the pram is standing securely.
12
To change the height of the
handle, press in the adjusting
buttons on both sides of the
handle.
In order to tilt the slide,
simultaneously pull the two
sockets 1 on the slide
upwards
and
then
tilting. Make sure that the
slide locks again in the two
main clasps on the left and
right and that it is not stuck.
Supplement to the parking brake
If you should notice a change to the braking action, loosen
the lock nut first in order to be able to implement settings
on the adjusting screw (unscrew). Then re-attach the lock
nut.
start
Attaching and removing the hood and/or cot
Place the top part on the frame in such a way that the bar
1 on each side of the base clicks into the correct slots 2.
Then slide the top part to the block. The catches then
lock automatically (the catch must "click").
Warning:
Before use, please check that the attachment and
seating unit are correctly clicked into place. The top part
is secure when the red area on the release mechanism
can no longer be seen. To remove the top part, push the
release lever 3 downwards until the lever locks (red area
is visible). Then pull the top part out of the slots and
remove it.
How to use the hood
Push the insert pieces for the hood joints into the cor-
responding openings on the armrest or on the carry-cot.
Attention: You must secure the press studs on the back
end of the cover onto the rear of the backrest as the co-
ver is also used as a protection against falling out.
If you need to remove the hood, undo the press studs on
the rear of the backrest; press the release buttons on the
insert pieces of the hood joints and pull the joints out of
the openings. You can open the zip at the top of the hood
for ventilation.
Publicidad
