Chicago Pneumatic CP 0122 SL Instrucciones De Seguridad Y De Funcionamiento página 10

Safety and operating instructions
► Immediately stop working if the machine
suddenly starts to vibrate strongly. Before
resuming the work, find and remove the cause of
the increased vibrations.
Never grab, hold or touch the inserted tool when
►
using the machine.
Participate in health surveillance or monitoring,
►
medical exams and training programs offered by
your employer and when required by law.
When working in cold conditions wear warm
►
clothing and keep hands warm and dry.
See the "Noise and vibration declaration statement"
for the machine, including the declared vibration
values. This information can be found at the end of
these Safety and operating instructions.
♦ Comply with the recommended air-pressure when
operating the machine. Either higher or lower
air-pressure has the potential of resulting in higher
levels of vibration.
DANGER Electrical hazard
The machine is not electrically insulated. If the
machine comes into contact with electricity, serious
injuries or death may result.
Never operate the machine near any electric wire
►
or other source of electricity.
► Make sure that there are no concealed wires or
other sources of electricity in the working area.
WARNING Concealed object hazard
During operating, concealed wires and pipes
constitute a danger that can result in serious injury.
Check the composition of the material before
►
operating.
Watch out for concealed cables and pipes for
►
example electricity, telephone, water, gas and
sewage lines etc.
► If the inserted tool seems to have hit a concealed
object, switch off the machine immediately.
Make sure that there is no danger before
►
continuing.
10
www.CrowderSupply.com • Toll Free: 888-883-5144
CP 0122 S, CP 0122 SL, CP 0125 S
WARNING Involuntary start
Involuntary start of the machine may cause injury.
Keep your hands away from the start and stop
►
device until you are ready to start the machine.
► Learn how the machine is switched off in the event
of an emergency.
Release the start and stop device immediately in
►
all cases of power supply interruption.
Whenever fitting or removing the insertion tool,
►
switch off the air supply, bleed the machine by
pressing the start and stop device and disconnect
the machine from the power source.
WARNING Noise hazard
High noise levels can cause permanent and disabling
hearing loss and other problems such as tinnitus
(ringing, buzzing, whistling or humming in the ears).
To reduce risk and prevent an unnecessary increase
in noise levels:
Risk assessment of these hazards and
►
implementation of appropriate controls is
essential.
► Operate and maintain the machine as
recommended in these instructions.
Select, maintain and replace the insertion tool as
►
recommended in these instructions.
If the machine has a muffler, check that it is in
►
place and in good working condition.
► Always use hearing protection.
Use damping material to prevent work pieces
►
from "ringing".
Maintenance, precautions
WARNING Machine modification
Any machine modification may result in bodily
injuries to yourself or others.
Never modify the machine. Modified machines
►
are not covered by warranty or product liability.
Always use original parts, insertion tools, and
►
accessories.
► Change damaged parts immediately.
Replace worn components in good time.
►
9800 0832 90b | Original instructions