Pur Line CHE-710 Manual De Usuario página 15

OPERATION
Power Switch (O/I)
- The main Power Switch must be turned ON in order to operate by Remote Controller or Manual Control
Board.
- If the power switch was turned off, then all functions off, while settings would be reserved for one week.
- When the fireplace is not in use or is to be cleaned or maintained, the main power switch must be turned
off, and the plug should be removed.
Operating the Fireplace by Remoter(see Diagram C) or Control Board(see Diagram B) and unit
status would be show on Displayer
Displayer
Remarks:
* 2pcs of AAA batteries required, BATTERIES NOT INCLUDED
* The remote control unit uses 2*AAA batteries. If the batteries are not fully charged the remote device may not
operate and the range of the device will be reduced.
Please open the door to operate on the
Diagram B
5 4 3
1. On/Off
2. Flame
3. Heater
4.
Timer
5.
Temperature
EN
Control Board
2 1
13
Diagram C
1
2
3
5
4