Pur Line CHE-710 Manual De Usuario página 16

A. On/Off
Note: When power switch was turned on, the fireplace was on standby status
- Press ON/Off button once, the flame would be turned on at level 3(high).
- Press ON/Off button again, all function turned off and the unit be on standby status.
- Without any operating in 3seconds, then all display would be turned off.
B. Flame on panel, or
-Flame brightness could be adjusted at 3 levels circularly, display as F1, F2, F3.
1) Press button once and the flame effect will be illuminated at level 1, and displayer show F1.
2) Press twice and the flame effect will be illuminated at level 2, and displayer show F2.
3) Press three times and the flame effect will be illuminated at level 3, and displayer show F3.
4) Press four times and the flame effect will be turned off.
C. Heat on panel, or
Note:
This function might be effected by "Adaptive Start" or "Weekly Setting" function. Please make sure that
"Adaptive Start" or "Weekly Setting" function were turned off, or not on, before use the heating function
separately. Those two functions could be turned off by pressing
- Press the button
1) Press twice, 2000W heater ON, and the displayer show H2.
2) Press the button three times, it would turn OFF heater, the displayer show 00.
- This button would also be used as "Confirm" or "OK" on "Time Calibration" Mode. (details as below)
D. Temp.(Adaptive Start)
- Press the button
the adaptive start function circularly.
1) Press or
2) Press the button twice, the displayer show 21
3) Press the button three times, the displayer show 24
4) Press the button four times, the displayer show 27
5) Press the button five times, the displayer show 30
6) Press the button six times, the adaptive start function would be turned off, and the displayer show 00
on remoter
on remoter
or once, 1000W heater ON, and the displayer show H1.
on panel or
or to set room temperature at 18ºC, 21ºC, 24ºC, 27ºC, 30 and turn off
button once, the displayer show 18.
EN
on remoter
14
button.