Pur Line CHE-710 Manual De Usuario página 17

- Adaptive Start Function
1) If room temperature is detected lower than set temperature, the heater would auto-start to work.
2) While if room temperature is detected higher than set temperature, the heater would be turned off
automatically.
Note:
Settings under this mode might effect the function of "Weekly Setting".
E. Timing on panel or
- Press the button to set the working time from 1~12 hours circularly. Number would be displayed on
control board.
1) Press the button once, the unit would work 1 hour, and number "01" displayed
2) Press the button twice, the unit would work 2 hour, and number "02" displayed
3) Press the button thirteen times, the timing function would be cancelled, and number "00" displayed
Note:
1) Timing setting only be applicable when Flame and/or Heat function on
2) When working time reached set time, the unit would be automatically turned off and on standby status.
3) When there is conflict on this set time and the Cut-off time under "Weekly Setting" mode, the unit would
be turned off as per the time whichever occurs earlier.
- Press and hold the button
1) The control board would display "00:00", and user could start to correct Hour firstly by pressing button
(as Up) and
2) Then press
3) Correct Minutes by pressing button
to 59.
4) Then press to confirm the Hour correction, and move to Date correction
5) Correct Date by pressing button
6) Then press to confirm the Date correction, and all setting completed
Note:
1- "d1"=Monday, "d2"=Tuesday........."d7"=Sunday,
on remoter
or
(as Down). Displayer would show 01 to 12.
to confirm the Hour correction, and move to Minutes correction.
(as Up) and
EN
2 seconds to enter Time Calibration mode.
(as Up) and (as Down). Displayer would show 01
(as Down). Displayer would show D1 to D7.
15