stayer HDBL1820K Manual De Instrucciones página 17

WORKING ADVICE
Auxiliary Handle/Depth Stop
Operate the machine only with the
auxiliary handle 10.
Loosen the handle by turning to the left. Rotate the
auxiliary handle 10 and adapt to the working position.
Make sure that the clamping handle 11 of the auxiliary
handle remains in the groove.
Then tighten the handle clockwise The drilling depth
can be set with the depth stop 3.
For this, press the push-button for the depth-stop
adjustment 4, adjust the required drilling depth and
release the push-button for the depth-stop adjustment
4 again. The ribbing on depth stop 3 must point
upwards.
CHANGING THE TOOL
Before any work on the machine itself, remove the
battery.
With the SDS-plus tool holder, simpler and easier tool
changing is possible without additional aids.
Grease the shank end of the tool regularly.
The dust protection cap 1 largely prevents the entry
of drilling dust during operation. When inserting the
tool, take care that the dust protection cap 1 is not
damaged.
A damaged dust protection cap should be changed
immediately. We recommend having this carried
out by an after-sales service.
As a requirement of the system, the SDS-plus tool
must rotate freely. At no-load speed, this leads to a
certain amount of radial run-out.
This does not affect the accuracy of the drill hole, as
the bit is automatically centred during drilling.
INSERTING
Clean and grease the shank end of the tool.
Insert the tool in a twisting manner into the tool holder
until it locks. Check if it has locked by pulling the tool.
REMOVING
Push back the locking sleeve 2 of the tool holder and
remove the tool.
SCREWDRIVING
The machine is also
screwdriving applications,
screwdriving applications with extreme reductions
of speed at which the overload clutch frequently
responds.
suitable for occasional
however, not for
-
For screwdriving, the universal bit holder with SDS-
plus shank (accessory) must be used.
– Set the impact stop switch 5 to "Drill".
– Set the direction of rotation to right-hand rotation.
– Regulate the speed with the On/Off switc h 6.
4_MAINTENANCE AND SERVICE
MANUTENZIONE E PULIZIA
Before any work on the machine itself, remove the
battery.
For safe and proper working, always keep the machine
and the ventilation slots clean.
Keep the tool holder clean at all times.
Changing the Dust Protection Cap
A damaged dust protection cap should be changed
immediately. We recommend having this carried
out by an after-sales service.
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should
be carried out by an after-sales service centre for
Stayer power tools.
In all correspondence and spare parts orders, please
always include order number given on the nameplate
of the machine.
REPAIR SERVICE
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts. Exploded views and information
on spare parts can also be found under:
info@grupostayer.com
Our customer consultants answer your questions
concerning best buy, application and adjustment of
products and accessories.
WARRANTY
Warranty card
Included in the documentation that accompanies this
equipment, you should find the warranty card. You
should fill out the card completely and return to vendor
with a copy of purchasing receipt or invoice and you
should receive a receipt.
Note: If you cannot find the warranty card within
the documentation, you must ask for it through
your supplier.
The warranty is limited only to manufacturing
defects and expire if pieces have been removed or
manipulated or repaired other than the manufacturer.
17 -
es
it
gb
de
fr
p
cz