Steinberg Systems SBS-TPG-100 Manual De Instrucciones página 18

3.4.
Cleaning and maintenance
a) Use only non-corrosive cleaning agents for cleaning the surfaces.
b) Store the unit in a dry and cool place protected from moisture and direct
sunlight.
c) Do not spray the unit with a stream of water or immerse it in water.
d) Make sure that no water enters through the ventilation openings in the casing.
e) Use a soft cloth for cleaning.
f) Do not leave the batteries in the unit when it will not be used for a long time.
g) Do not use sharp and/or metal objects (e.g. a wire brush or metal spatula) for
cleaning, as these may damage the surface of the material from which the unit
is made.
h) Do not clean the unit with acidic substances, medical products, thinners, fuel,
oil or other chemicals as this may damage the unit.
INSTRUCTIONS FOR THE SAFE DISPOSAL OF BATTERIES.
The units are equipped with CR2032 3V batteries.
Remove used batteries from the unit in the same way you put them in.
Return the batteries to a unit responsible for their disposal.
DISPOSAL OF USED UNITS.
At the end of its useful life, this product should not be disposed of with normal
household waste but should be taken to a collection point for the recycling of
electrical and electronic equipment. This is indicated by the symbol on the
product, operating instructions or packaging. The materials used in this unit are
recyclable according to their marking. You will be making an important
contribution to protecting our environment by reusing, recycling or otherwise
disposing of used units.
Your local administration will provide you with information about the
appropriate disposal point for used units.
NOTE: the pressure reading is displayed only for 15
seconds after the measurement is completed.
IMPORTANT: measure the pressure on a cold tire, i.e.
after the vehicle has been parked for at least 3 hours or
after parking it without driving more than approx. 1 km.