Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
CONNECTING HIGH PRESSURE HOSE TO TRIGGER HANDLE
See Figure 7.
• Align the pressure hose with the trigger handle and push up and into position.
• With hose pushed into position on the trigger handle, secure in place by turning the hose lock
clockwise until fully tightened.
NOTE: For easier installation of the hose to the unit or trigger, it is suggested to add pressure
washer or dish detergent to the rubber seal at each end of the hose. This will allow for easier
installation and a snug fit.
• Connect the other end of the hose to the water outlet connector.
i
d
Fig. 7
14
Publicidad
