HOMCOM 820-321V00 Manual Del Usuario página 4

-During filling, air the room, do not smoke, switch off mobile phones.
-Do not use a manual or electric pump directly to fill up the tank.
-The tank shall be filled while the appliance is switched off (fire safety).
-Comply with the conditions in force for fuel storage (examples: health regulation,
co-ownership regulation.
-It is recommended not to store the fuel in containers which are not equipped with child-proof caps
compliance with EN ISO 8317.
Installation and Assembly
-The fireplace must only be installed on a solid, flat and stable surface of non-flammable material.
-Please remove all packaging and Information material before assembly.
-Please make sure to use a raw plug that suits the walls construction. For wall mounted unites,
There should NOT be any electrical cables and outlets located behind your fireplace.
Starting up
Filling the burner box or cylindrical burners:
-Fill the burners with the fuel up to the maximum of 2/3 of each burner.
-Spilled alcohol must be removed with an absorbent tissue and cleaned with water to prevent
ignition outside the burner reservoir.
-CAUTION: Spilled alcohol may lead to matt stains on parquet or equal flooring.
-ATTENTION: The fuel should be stored at room temperature to facilitate its ignition.
-CAUTION: Fuel must be stored in safe place (min. 1m / 40 inch) to the fireplace.
-Do not place fuel in front of the fireplace.
-In case the flame does not ignite, please repeat the ignition process until the flame burns steadily.
-Fuel will burn low at first. Please allow 15 minutes to reach optimum temperature and flame height.
-Ignite the fire form a horizontal minimum distance is 200mm.
REFILL WARNING
Refill:
-Check carefully if there is no longer any fire on the surface. Fire have to be fully extinguished.
-WARNING! NEVER FILL A BURNING BURNER! Wait at least 20 minutes for the burner to cool
down.
For further instructions see: "Starting Up / Filling".
EXTINGUISH
-Please use the extinguisher tool provided in the kit. Never blow out the flame in order to put it out,
this will only increase the flame.
-CAUTION: Never extinguish the flame with water!
-Let the fuel burn out completely if possible. This prevents alcohol left in the reservoir and
deflagration when reigniting.
-If you wish to extinguish the flame before the fuel has completely burned out. Please use the
extinguisher tool to fully close the opening of the fuel can, and wait until the flame is extinguished.
-Wait approximately 30 minutes until the burner has reached room temperature. Only then dispose
remaining fuel.
-In case when the flame is not extinguished immediately, close the cover and wait approximately 10-
15 minutes to allow the flame to cool down. Repeat the above instructions until the flame is fully
extinguished.
MAINTENANCE AND CLEANING INSTRUCTIONS
-You can use a wet cloth to clean the internal surface of a fireplace The burner can change color
because of the heat. The stainless steel will have another appearance after a while, This is normal.
A regular maintenance will keep its color. Do not clean with water or put in a dishwasher. Go across
the slot and the surface of the burner with a little bit of bio ethanol on a paper towel.
-CAUTION: Never use chemicals, steel wool or scrubbing sponges either. These can scratch the
surface. The manufacturer cannot be held responsible for any damages resulting out of false use
and / or cleaning of the product.
-Repair, replacement of major parts and work on safety elements shall only be carried out by
approved specialists (recognized by the manufacturer or importer).
The facts that some components (single part or set of parts that make up a specific element) are
essential to product safety and are likely to alter performance.
-During maintenance or repair operations, if any, only original components recognized as equivalent
shall be sued.
-Check the fireplace periodically, especially in winter, keep the ethanol burners empty when not use.
.
3