Starting The Tool; Operate The Deadman's Handle; Operating The Light Switch - Holmatro GCT 41 EVO 3 Serie Manual Del Usuario

5.5

Starting the tool

• Operate the on/off switch to activate the tool. The green LED will light and the electric motor runs at
slow speed.
• The tool operates if the deadman's handle is turned to position
NOTICE
If the tool is not used, it will switch off after a while. The green LED will blink. Press the on/off
switch 2 times to re-activate the tool.
NOTICE
When the tool is not used for 10 minutes the battery pack will switch off. The green LED will
not light anymore. To activate the battery pack again:
• Press the SOC indicator button, or
• Operate the on/off switch again, or
• Reinstall the battery pack.
5.6

Operate the deadman's handle

The deadman's handle is used to determine the movement of the plunger(s). In the neutral position no
pressure is built up and the oil flows back to the pump without pressure. If the deadman's handle is
released, it returns automatically to the neutral position and stops the movement of the plunger(s).
/i
Hold the deadman's handle in this position to open the tool/blades. Pressure is built
up in the tool. Return oil from the tool flows back to the pump without pressure.
Hold the deadman's handle in this position to close the tool/blades. Pressure is built
up in the tool. Return oil from the tool flows back to the pump without pressure.
5.7

Operating the light switch

On the carrying handle there is a light switch for the integrated LED lights.
• Press the light switch to turn the LED lights on and off.
• The battery for LED lights should be replaced when the LED lights no longer turn on when the light
switch is pressed.
5.8 Chain connecting pieces sets and pull chain sets
Chain connecting pieces make it possible to use a combi tool for pulling. The chain connecting pieces
must be placed on the blades. The chain connecting pieces may only be used in combination with the
corresponding pull chain set. These pull chain consist of two parts, each with a shortening hook that
only grabs the chain. The chains are 1.5 m and 3 m long respectively.
WARNING
Hoisting is not permitted with these accessories.
The pulling accessories are intended solely for the horizontal movement of loads.
CAUTION
Check what the load is doing and make sure that it is always supported.
Make sure that the tool can move freely during pulling and always remains in a straight line
between both pulling attachments.
GCT 41** EVO 3 916.001.670_001
or .
EN
43