Descargar Imprimir esta página

Napoleon ROGUE R365 Manual Del Usuario página 19

Ocultar thumbs Ver también para ROGUE R365:

Publicidad

Idiomas disponibles

Idiomas disponibles

Troubleshooting
Lighting Problems
• Main, rear or side burners will not light with the igniter, but will light with a match.
• Burners will not cross light each other.
Possible causes
JETFIRE
TM
outlet is dirty or clogged
Dirty or corroded cross light brackets.
Dead battery, or installed incorrectly.
Loose electrode wire or switch terminal wires.
Lifting flames on burner.
Noises and Flare-ups
• Humming regulator.
• Excessive flare-ups and uneven heat.
Possible causes
Normal humming noise on hot days.
The cylinder valve was opened too quickly.
Sear plates installed incorrectly.
Improper heating.
Excessive grease and ash build on sear plates and in drip
pan.
REGISTER
YOUR
GRILL!
Register your grill! Go
to Napoleon.com or
your Assembly Guide
for replacement parts
instructions.
WE WANT
TO HELP!
Napoleon is here to ensure
your grilling experience
is memorable. Contact us
if you require additional
help.
Napoleon.com | Rogue® Series Grills
Solution
Clean JETFIRE
TM
outlet with a soft bristle brush.
Clean or replace as required.
Replace with premium heavy- duty battery.
Check electrode wire is firmly pushed onto the terminal on the
back of the igniter. Check the lead wires from the module to the
ignition switch (if equipped) are firmly pushed onto their respective
terminals.
Close air shutter according to "Maintenance Instructions"-
Combustion Air Adjustment section in this Owner's Manual.
IMPORTANT! This must be done by a qualified gas installer.
Solution
This isn't a defect. It's caused by internal vibrations in the
regulator and doesn't affect the performance or safety of the grill.
Humming regulators WILL NOT be replaced.
Open cylinder valve slowly
Ensure sear plates are installed with holes towards the front, and
the slots on the bottom. See Assembly Instructions Guide.
Preheat grill with all main burners on high for 10 to 15 minutes.
Clean sear plates and drip pan regularly. Do not line pan with
aluminum foil. Refer to "Cleaning Instructions".
1
2
3
19
Troubleshooting |

Publicidad

loading