Table saw
Hole diameter
Table saw
Article number
Rated power input
Rated current
Rated voltage
Frequency
No-load speed
Starting current limitation
Run-out brake
Overload protection
Weight according to EPTA-Procedure
01:2014
Protection class
Dimensions (including detachable parts of the tool)
Width x depth x height
Dimensions of suitable saw blades
Saw blade diameter
Base blade thickness
Min. tooth thickness/offset
Hole diameter
Maximum workpiece dimensions: (see "Maximum workpiece dimensions", page 44)
Noise information
Noise emission values determined according to EN
62841-3-1.
Typically, the A-weighted noise level of the power tool is:
Sound pressure level 92 dB(A); sound power level 105
dB(A). Uncertainty K = 3 dB.
Wear hearing protection
The noise emission value given in these instructions has
been measured in accordance with a standardised measur-
ing procedure and may be used to compare power tools. It
may also be used for a preliminary estimation of noise emis-
sions.
The noise emission value given represents the main applica-
tions of the power tool. However, if the power tool is used
for other applications, with different application tools or is
poorly maintained, the noise emission value may differ. This
may significantly increase noise emissions over the total
working period.
To estimate noise emissions accurately, the times when the
tool is switched off, or when it is running but not actually be-
ing used, should also be taken into account. This may signi-
ficantly reduce noise emissions over the total working
period.
Bosch Power Tools
GTS 10 XC
mm
30
GTS 10 XC
3 601 M30 442
W
A
V
220−240
Hz
50/60
-1
min
3200
kg
35.0
mm
810 x 768 x 343
mm
mm
<2.2
mm
>2.4
mm
25.4
Assembly
Avoid starting the power tool unintentionally. The
u
mains plug must not be connected to the power supply
during assembly or when carrying out any kind of
work on the power tool.
Items included
Check to ensure that all the parts listed below have been
supplied before using the power tool for the first time:
– Table saw with fitted saw blade (33) and riving knife (7)
– Angle guide (3)
– Profile rail (34)
– "Profile rail" fastening set (55) (guide plate, knurled nut,
screw, washer)
– Parallel guide (8)
– Additional parallel guide (52)
– "Additional parallel guide" fastening set (39) (3 fastening
screws, 3 washers, 3 wing nuts)
– Protective cover (6)
– Table extension (10)
– "Table extension" fastening set (43) (2 fastening screws,
2 washers, 1 open-ended spanner)
– Hex key (37)
– Ring spanner (15)
– Saw blade storage compartment cover (14)
English | 39
GTS 10 XC
GTS 10 XC
30
GTS 10 XC
3 601 M30 4B2
−
2100
9.1
3200
●
●
●
35.0
/ II
810 x 768 x 343
254
<2.2
>2.4
25.4
1 609 92A 4PX | (20.03.2019)
30
−
220
60
●
●
●
/ II
254