Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Symbol
Name
DANGER ---
Thrown Deb-
ris
DANGER ---
Steep Slope
Hazard
5
RISK LEVELS
The following signal words and meanings are intended
to explain the levels of risk associated with this product.
SYM-
SIGNAL
BOL
DANGER
WARNING
CAUTION
CAUTION
6
INSTALLATION
Do not change or make accessories that are not
recommended by the manufacturer.
Do not connect the machine to the power supply until
you assemble all the parts.
6.1
UNPACK THE MACHINE
Make sure that you correctly assemble the machine
before use.
Explanation
Remove objects that can
be thrown by the blade in
any direction. Wear safe-
ty glasses.
Use extra caution on
slopes. do not mow
slopes greater than 15
degrees.
MEANING
Indicates an imminently
hazardous situation,which,
if not avoided, will result in
death or serious injury.
Indicates a potentially haz-
ardous situation,which, if
not avoided, could result in
death or serious injury.
Indicates a potentially haz-
ardous situation, which, if
not avoided, may result in
minor or moderate injury.
(Without Safety Alert Sym-
bol) Indicates a situation
that may result in property
damage.
WARNING
WARNING
WARNING
English
•
If the parts have damage, do not use the machine.
•
If you do not have all the parts, do not operate the
machine.
•
If the parts are damaged or missing, speak to the
service center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with
local regulations.
6.2
INSTALL THE LOWER HANDLE
Figure 2.
1. Move the lower handle along with the groove in the
side plate.
2. Align the holes in the lower handle and the groove.
3. Put the wing nut through the hole and tighten it.
4. Do the same operation on the other side.
6.3
INSTALL THE UPPER HANDLE
Figure 3.
1. Align the holes in the upper handle and the lower
handle.
2. Put the bolts through the holes.
3. Tighten the knobs onto the bolts.
4. Do the same operation on the other side.
6.4
INSTALL THE GRASS CATCHER
Figure 4.
1. Open the rear discharge door and hold it.
2. Hold the the grass catcher by its handle and put the
hooks over the slots.
3. Close the rear discharge door.
6.5
SET THE BLADE HEIGHT
The machine can be set to different blade heights.
Figure 5.
1. Pull the height adjustment lever rearward to
increase the blade height.
2. Pull the height adjustment lever forward to decrease
the blade height.
6
WARNING
Publicidad
