Descargar Imprimir esta página

Ryobi RY142022 Manual Del Operador página 18

Publicidad

Idiomas disponibles

Idiomas disponibles

POWER SUPPLY CORD REPLACEMENT
If replacement of the power supply cord is necessary, this
must be done by an authorized service center in order to
avoid a safety hazard.
PUMP LUBRICATION
The pump on this unit is lubricated with a sufficient amount
of high grade lubricant for the life of the unit under normal
operating conditions. Therefore, no further lubrication is
required.
PUMP MAINTENANCE
Routinely make a visual inspection of the pump. If you notice
any leaking of lubricant around the pump seals, take the
pressure washer to an authorized service center for repair.
There are no user serviceable parts to the pressure washer
pump. Any attempt to service or alter the pump may dam-
age the pressure washer and void your product warranty.
NOZZLE MAINTENANCE
See Figure 17.
Excessive pump pressure (a pulsing sensation felt while
squeezing the trigger) may be the result of a clogged or
dirty nozzle.
 Turn off the pressure washer and shut off the water sup-
ply. Pull trigger to release water pressure.
 Unplug the pressure washer.
 Remove the nozzle from the spray wand.
WARNING:
NEVER remove nozzles without first turning off the motor,
relieving the water pressure in the trigger handle, and
locking the lock out on the trigger handle. NEVER point
the nozzle at your face or at others. The quick-connect
feature contains small springs that could eject the nozzle
with some force. Failure to follow these instructions could
result in an eye injury or other serious personal injury.
 To free any foreign materials clogging or restricting the
nozzle, blow out or remove debris with a straightened
paper clip or fine needle (not included).
This product has a Three-year Limited Warranty for personal,
family, or household use (90 days for business or commercial use).
For warranty details, visit www.ryobitools.com
MAINTENANCE
or call (toll free) 1-800-860-4050.
14 — English
 Using a garden hose, flush debris out of nozzle by back
flushing (running the water through the nozzle backwards
or from the outside to the inside).
 Reconnect the nozzle to the spray wand.
 Reinstall the garden hose and connect the unit to the
power supply.
STORING THE PRESSURE WASHER
See Figures 18 - 19.
NOTE: Regular use of pump protector will give you better
performance of the unit and increase the life of the pump.
Store in a dry, covered area where the weather can't damage it.
It is important to store this product in a frost-free area. Always
empty water from all hoses, the pump, and the soap tank
before storing.
 Make sure the on/off switch is in the off (O) position.
 Unplug the pressure washer and store the power cord
by wrapping the cord around the brackets on the back
of the unit.
 Disconnect both the high pressure hose and the garden
hose from the pump.
 Neatly coil the high pressure hose and store with hook
and loop strap.
 Tilt the unit as shown to allow any remaining water in the
pump to drain from the pump outlet.
NOTICE:
If the location where your pressure washer is stored will
fall below 32°F, the use of a pump protector is required
before storing to prevent freeze damage. Freeze damage
will void your warranty.
 Turn the spray wand counterclockwise to remove it from
the trigger handle. Store the unassembled spray wand
and trigger handle in their storage areas.
 Store the unit and accessories in an area that does not
reach freezing temperatures. Do not store near furnace or
other sources of heat that could dry out the pump seals.
NOTE: This unit may be stored in a horizontal or vertical
position.

Publicidad

loading