DeWalt D25002 Manual Del Usuario página 21

Check for misalignment and seizure of moving
parts, breakage of parts and any other conditions
that may affect its operation. Have damaged
guards or other defective parts repaired or
replaced as instructed. Do not use the tool if the
switch is defective. Have the switch replaced by
an authorized D WALT repair agent.
E
20 Have your tool repaired by an authorized
D WALT repair agent
E
This Power Tool is in accordance with the
relevant safety regulations. To avoid danger,
electric appliances must only be repaired by
qualified technicians.
Package contents
The package contains:
1 Pistol Grip Heavy Duty Rotary Hammer Drill
1 Side handle
1 Depth adjustment rod
1 Kitbox (K-models only)
1 Keyed chuck + chuck adaptor
(D25002KC/D25003KC)
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or accessories
which may have occurred during transport.
• Take the time to thoroughly read and understand
this manual prior to operation.
Description (fig. A)
Your D Walt Heavy Duty Rotary Hammer Drill
E
D25002 has been designed for professional drilling,
hammer drilling and screwdriving applications.
Your D Walt Heavy Duty Rotary Hammer Drill
E
D25003 has been designed for professional rotary
and hammer drilling, screwdriving and light chipping,
chiselling, demolition applications and for carbide
tipped core drilling.
1 Variable speed switch
2 Lock-on button
3 Forward/reverse lever
4 Mode selector
5 Side handle
6 Depth adjustment rod
7 Dust cover
8 Tool holder
Torque limiting clutch
All Rotary Hammer Drills are equipped with a torque
limiting clutch that reduces the maximum torque
reaction transmitted to the operator in case of jamming
of a drill bit. This feature also prevents the gearing and
electric motor from stalling. The torque limiting clutch
has been factory-set and cannot be adjusted.
Electrical safety
The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your D WALT tool is double insulated in
E
accordance with EN 50144; therefore no
earth wire is required.
Mains plug replacement
(U.K. & Ireland only)
• Should your mains plug need replacing and you
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorized
D WALT repair agent or a qualified electrician.
E
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely; a plug
with bared copper conductors is dangerous if
engaged in a live socket outlet.
• Only fit 13 Amperes BS1363A approved plugs
fitted with the correctly rated fuse (1).
• The cable wire colours, or a letter, will be marked
at the connection points of most good quality
plugs. Attach the wires to their respective points
in the plug (see below). Brown is for Live (L) (2)
and Blue is for Neutral (N) (4).
• Before replacing the top cover of the mains plug
ensure that the cable restraint (3) is holding the
outer sheath of the cable firmly and that the two
leads are correctly fixed at the terminal screws.
E N G L I S H
21