Rapid PRO EG380 Manual De Instrucciones página 3

ELECTRIC HOT MELT APPLICATOR: EG380
Operating instructions - Original
Technical Characteristics
Dimensions (WxHxD)
Weight :
Working voltage :
Power rating :
Temperature :
Regulation :
Glue sticks:
Special features
• Non breakable handle and light
weight
• Unique effort-saving trigger,
with circular TPR handle for
comfortable hour long operation
• Temperature adjustor between
140-220°C
Safety Instructions
Read safety rules and
instructions carefully before
using this machine.
WARNING : This tool must
be placed on its stand when
not in use.
• This appliance is not intended
for use by persons (including
children) with reduced physical,
sensory or mental capabilities,
or lack of experience and
knowledge, unless they have
been given supervision or
instruction concerning use
of the appliance by a person
responsible for their safety.
Children should be supervised to
ensure that they do not play with
the appliance.
• Do not use or store this machine
in a humid environment. Do not
place it where it may be splashed
4
36 x 24 x 8 cm
1.7 kg
220V-240V~, 50Hz
400W
140° - 220°C
Thermostat
Rapid Ø 12mm
by water. Do not expose it to
extreme changes in temperature
during or directly after use.
• Only use it indoors on a clean, dry
work surface. Excessive dust and
dirt may reduce lifetime of this
tool.
• Never unplug the machine by
pulling the cable.
• If the power cable is damaged
or cut, remove the plug from the
electric socket immediately and
do not use the machine. It must
be replaced by the manufacturer
or its service agent or a similar
qualified person in order to avoid
a hazard.
• Unplug the machine when not
in use, before any servicing
operations (maintenance,
cleaning etc.)
• Always verify that the appliance is
attached to a ground socket.
• When using an electric extension
cable, check that it is in good
working order and that it has a
ground socket.
• Never use the tool if it is damaged
in any way.
• Never insert objects other than
Ø12mm Rapid glue sticks into
the machine.
• Never remove a glue stick that
has already been inserted.
• The EVA adhesive can be stored
indefinitely in the unheated gun
and re-melted by heating up the
tool. Use only recommended
adhesives in this glue gun.