Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly - Attaching the Light Kit
1
Attaching the light kit fitter assembly
□
Connect the wires from the light kit assembly (E) to the wires
from the fan motor assembly (C) by connecting the molded
adaptor plugs together. Carefully tuck all wires and splices
into the switch cup and connect the safety cable (SS) from the
light kit assembly (E) to the hook from motor assembly (C).
□
Push the light kit assembly (E) up to the motor assembly (C)
by aligning the magnet part of the motor assembly (C) until it
is secure.
Assembly - Preparing the Remote Control
Preparing the remote control
NOTE: The remote control has already been paired to the
ceiling fan for your convenience. If you have two of the same
model fans in your home, please follow the steps below to
control each fan independently.
NOTE: The remote control battery will weaken with age and
should be replaced before leaking takes place, as this will
damage the remote control. Dispose of used battery properly
and keep the battery out of the reach of children.
□
Confirm that the power to the fan is off at either the wall
switch or breaker box.
□
Remove the battery cover by pressing firmly on the arrow
and sliding the cover off.
□
Install the 23A battery (H).
□
Return power to the fan at the wall switch or breaker box.
□
Press and release the "Learn" button for 1-2 seconds,
located in the remote's battery compartment within 30
seconds of turning on the power.
□
If pairing is successful, the fan's light kit will flash and the
blades will begin to spin.
□
Replace the battery cover on the remote control.
1 to 3 mode
□
To use more than one remote control for your fan, press
the "Learn" button for 10 seconds and release within
30 seconds of turning on the power. Once pairing is
successful, the fan's light kit will flash and the blades will
begin to spin.
□
Repeat the above process for the remote controls you want
to work with this fan.
□
The fan can be only controlled by 3 remote controls
maximum at the same time after "Learning". If you use a
fourth remote control to handle the fan, the first remote
control will be replaced.
1 to 1 mode
□
To use only one remote control for your fan, press and
release the "Learn" button for 1-2 seconds within 30
seconds of turning on the power. The "1 to 3" mode will be
cleared and returned back to "1 to 1" mode.
10
C
SS
E
Publicidad
