Bosch TracRac T3B Instrucciones De Funcionamiento Y Seguridad página 2

IMPORTANT SAFETY INSTRUCTIONS FOR USING THIS UNIVERSAL WORKSTATION
Read and understand all instructions. Failure to
WARNING
!
follow all instructions listed below and in your miter
saw manual may result in serious personal injury.
This Universal Workstation is designed to be used with BOSCH
(3912, 3915, 4212, 4410, 4412) HITACHI (C8FB2, C10FCB, C10FM,
C10FCD, C10FSH/FSB), DEWALT (DW703, DW705S, DW706,
DW708), and DELTA (36-075, MS275) Miter Saws . Other units have
not been verified for use with the TracRac system.
Fully assemble and tighten all the fasteners required for this
stand. Also remember to occasionally check the stand and make
sure it is still tight. A loose stand is unstable and may shift in use and
cause serious injury.
Turn tool switch off and disconnect power before mounting to the
stand. Unintended startup during assembly can cause injury.
Before operating make sure the entire unit is placed on a solid,
flat, level surface. Serious injury could occur if tool with stand is
unstable and tips.
Never stand on tool or its stand or use as ladder or scaffolding.
Serious injury could occur if the tool is tipped or the cutting tool is
accidentally contacted. Do not store materials on or near the tool such
that it is necessary to stand on the tool or its stand to reach them.
Use only Bosch replacement parts. Any others may create a hazard.
The Miter Saw should be firmly mounted to the Universal Workstation
per the instruction manual.
After mounting the Miter Saw to the Universal Workstation, align, posi-
QUICK START
1. Fold out legs
2. Mount saw parallel to beam
3. Align work supports with saw table
4. Align roller fences with saw fence
5. Extend arm
6. Stabilize table
7. Cut wood
4
5
3
Move
handle to
"tighten"
position to
lock
1
tion and balance the Miter Saw per the instruction manual.
Before use, verify that all Universal Workstation parts are free from
damage and/or deformity.
Before use, verify that all parts or components of the Universal
Workstation are properly installed.
Before use, swing open each of the legs until the brass pin clicks, lock-
ing the legs in position.
When mounting the Miter Saw to the Universal Workstation, make sure
that the tool mount handles are in the "UNLOCK" position, so the tool
mount will engage with the main beam. Be sure to hold the saw until it
is secured to prevent it from falling off the main beam. Handles should
then be tightened.
When removing the Miter Saw from the Universal Workstation, loosen
the tool mount handles until they rotate to the "UNLOCK" position. Hold
the Miter Saw firmly to prevent the saw from falling off the main beam.
Carefully remove the Miter Saw.
Do not modify the Universal Workstation in any manner or use the
Universal Workstation for any purpose other than is stated in these
instructions.
Because cut material may cause the workstation to become
unbalanced, always be sure the material is supported properly. Also, if
the piece being cut is placed far beyond the work support,
workstation legs on the opposite side may suddenly be lifted up due to
weight imbalance. To prevent this from occurring, hold the opposite
side firmly before cutting.
2
Move
handle to
"unlock"
position to
slide or
remove
2
Tools needed
• 1/2" open-end wrench
• Socket wrench with 1/2" socket
• 3/8" open-end wrench
• Flat-head screwdriver - medium tip
• 7/8 open-end wrench
• 7/16 open-end wrench
• 5/32 allen wrench
• 9/16 hex wrench
• 3/16 allen wrench
6