Bosch TracRac T3B Instrucciones De Funcionamiento Y Seguridad página 3

WHEEL BRACKET ASSEMBLY
Hammer on end
caps
1
Wheel bracket can be
attached to either end
of the workstation
Attach Wheels
First remove end caps. With the workstation
upside-down and legs in the closed position,
align holes on the wheel bracket with those on
the leg bracket. Insert 1/4'' screws at the
widest end of the bracket.
Tighten by holding the screw head with a
5/32'' allen wrench and turning the nut with a
7/16'' wrench.
2
Unfold the legs and fasten the remaining two
screws, as in the previous step.
Be sure that nuts face out-
!
WARNING
ward.
3
3
Set up Main Beam
Set up beam by folding out each of the legs.
Make sure the brass pin
!
WARNING
clicks, locking the legs in
position.
BAG
1