Maintenance; Mounting The Trimmer Head; Replacing Trimmer Line - Oregon Professional 120V Serie Manual De Instrucciones

Maintenance

Mounting the Trimmer Head

WARNING:
To reduce risk of injury,
disconnect the battery from the power tool
before making any adjustments, changing
accessories, or transporting.
• Use only Oregon Lightning Load trimmer
head
• Place the string trimmer so that the threaded
shaft (1) coming out of the gear box faces
upwards
• Be sure that the thrust plate (2) is in place on
the gear box over the spline on the threaded
shaft
• Insert the blocking pin into the shaft block
hole (3) in the gear box so that the pin stops
the threaded shaft rotation Note, the shaft
block hole has a rubber stopper designed to
hold the blocking pin in place while mounting
or removing the trimmer head
1
2
3
• With the blocking pin in place and one hand
holding the gear box, rotate the trimmer head
counter clockwise with other hand to tighten
FIRMLY until you can no longer rotate the
head (4)
• Remove the blocking pin from the gear box
• Remove the trimmer head in reverse, rotating
the trimmer head clockwise (5)
4
16
Maintenance
5

Replacing Trimmer Line

WARNING:
To reduce risk of injury,
disconnect the battery from the power tool
before making any adjustments, changing
accessories, or transporting.
Before replacing the trimmer line:
• Use only Oregon 0.095" Magnum Supertwist
Line or Generic 0.095 mm round nylon line.
• Pull any remaining trimmer line through an
eyelet of the trimmer head.
• Cut a length of new trimmer line about 25 ft
(7.6 m) long.
• Turn the knob so the arrows on the surface of
the head point to the eyelets on the trimmer
head.
To replace the trimmer line:
• Insert trimmer line through an eyelet in the
side of the trimmer head (1) until the trailing
end of the trimmer line exits through the
other eyelet in the trimmer head (2).
1
String Trimmer Model ST120VX-NA
2