Publicidad
Idiomas disponibles
Idiomas disponibles
LOW PROFILE MOUNT INSTALLATION
4. Wire the fan
WARNING
We know wiring is hard. That's why we make it easier for you!
Connect the PINs connectors wires: From the receiver to the motor.
• (fan with light will connect 2x PINS). Fan and light.
• (fan without light will connect 1x PIN). Fan only.
The 3 wires coming out from the receiver.
Black - L: "hot" power for the fan
White - N: "common" for the fan
Green: Ground Wire
1. Black (L) hot wire from the receiver should be connected to the black wire in the ceiling using a
wire nut to make the connection.
2. White (N) neutral wire from the receiver should be connected to the white wire in the ceiling, using
a wire nut to make the connection.
3. The ground (green) wire from the receiver should be connected to the ground wire in the ceiling
and to the ground of the hanging system, using a wire nut to make the connection.
4. Hide receiver inside the main body.
(see figures 18,19,20)
WARNING
The ceiling fan must be grounded. If the ground wire for the
installation site is not present, immediately STOP installation and
consult a qualified electrician.
26
To avoid possible electrical shock, before installing your
fan, disconnect the power by turning off the circuit breakers
to the outlet box associated with the wall switch location.
All wiring must be in accordance with national and local
electrical codes ANSI/NFPA 70. If you are unfamiliar with
wiring or in doubt, consult a qualified electrician.
WARNING
Publicidad
