JAROLIFT TDEP10/14 Instrucciones Originales página 27

1. Use a Phillips screwdriver to remove the two
screws on the motor head, then remove the
bracket plate, and pull the square pin out of the
motor head.
2. Then mount the motor head plate (metal) of
the click bracket on the motor head using the
supplied screws. ATTENTION! Never use screws
other than those included in the delivery!
3. Mount the click bracket (plastic) on the side
panel of your roller shutter casing. Make sure
that the bracket is mounted in a centered posi-
tion. In the case of external elements, you can
leave the round pin in the side, as it fits exactly
into the central recess of the click bracket as
well as into the now accessible opening in the
motor head.
4. Click the motor into the bracket using the motor
head plate. Make sure that the side hooks of the
plastic bracket "click" into place on the metal
plate.
1
2
3
4
INSTALLATION
27