JAROLIFT TDEP10/14 Instrucciones Originales página 30

ELECTRICAL CONNECTION
ATTENTION!
There is a danger to life from electric shock when working on electrical equipment!
The mains connection of the tube motor and all work on electrical installations may only be
carried out by an authorized electrician and in accordance with the respective connection
diagrams of the device. Carry out all assembly and connection work in a de-energized state.
Wiring diagram - actuator with electronic limit switches without radio receiver.
Switch box
L1
N
PE
30
ATTENTION!
Switches and circuits (controls) must
not allow a simultaneous up and
down command!
An up and down command given si-
multaneously will short circuit the run
capacitor.
Only electrically or mechanically in-
terlocked switches (not light switches)
may be used.
ATTENTION!
After connecting the control the con-
trol/switch, check the OPEN/STOP/
DOWN functions.
The direction of rotation of the motor
depends on the installation position
(left/right) as well as on the winding
direction of the roller shutter (left roller/
right roller).
If the motor (shutter) should move
in downward direction when the UP
button is pressed, the brown and black
wires (UP/DOWN) must be swapped.
L1 L1 Direction of rotation 1 (black)
L2 L2 Direction of rotation 2 (brown)
N N Neutral conductor (blue)
PE PE Protective conductor (green-yellow)