Stahlwille Manoskop 730D Serie Instrucciones De Servicio página 36

EN
Inserting rechargeable batteries/standard
batteries

A suitable coin, etc. is required to open the battery
compartment cover.
Attentio n
A torque wrench malfunction is possible.

Switch off the torque wrench before changing the
rechargeable batteries/batteries.

Make sure that the torque wrench is switched off.

Turn the cover counter clockwise to stop using the
coin.

Remove the cover.

Insert the rechargeable batteries or standard
batteries, observing the polarity specified on the
handle.

Insert the cover into the battery compartment
recesses.

Press gently on the cover using the coin.

Turn the cover clockwise to stop using the coin.
Taring the torque wrench
WA RNING
Risk of injury due to incorrect
measured values during taring.

Make sure that the torque wrench is not moved or
placed under strain during the taring process.
To ensure precise measurement, the torque wrench
must be tared during each bolting process.
Automatic taring

Switch off the torque wrench and place it on a flat
surface.

To tare the torque wrench with an insert tool
mounted, allow this to project e.g. over the edge
of the bench.

Make sure that no forces are acting on the torque
wrench.

Keep the torque wrench steady throughout the
entire taring process.

Press any button to switch on the torque wrench.
The software version number is shown in the display.

Briefly press the OK button.
If the "Save values" function is switched on, the four-
digit bolting application number is displayed.
10

To confirm the bolting application, press the OK
button.

To create a new bolting application, proceed as
described on page 14.
The current torque value which is set is displayed.
The "TARA!" symbol flashes in the display. The torque
wrench is tared within a few seconds.
If a value of more than 0.1 is displayed in the display,
tare the torque wrench manually.
Manual taring

Switch off the torque wrench and place it on a flat
surface.

To tare the torque wrench with an insert tool
mounted, allow this to project e.g. over the edge
of the bench.

Make sure that no forces are acting on the torque
wrench.

Keep the torque wrench steady throughout the
entire taring process.

Press the OK button for longer than two seconds.
The taring process starts. Four horizontal dashes are
shown in the display. The "TARA!" symbol flashes.
If a value of more than 0.1 is displayed in the display,
then tare the torque wrench again.