Bosch GWS Professional 15-125 CIEH Manual Original página 27

OBJ_BUCH-165-005.book Page 28 Wednesday, July 28, 2010 8:54 AM
28 | English
Assembly
Mounting the Protective Devices
Before any work on the machine itself, pull
the mains plug.
Note: After breakage of the grinding disc during
operation or damage to the holding fixtures on
the protection guard/power tool, the machine
must promptly be sent to an after-sales service
agent for maintenance (for addresses, see sec-
tion „After-sales Service and Customer
Assistance".
Protection Guard for Grinding
Place the protection guard
12 onto the spindle collar
as shown in the illustra-
tion. The triangle marks on
the protection guard must
correspond with the re-
spective marks on the gear
case.
Press the protection guard
12 onto the spindle collar
until the shoulder of the
protection guard is seated
against the flange of the
machine, and turn the protection guard until it
can clearly be heard to engage.
Adjust the position of the protection guard 12 to
the requirements of the work process. For this,
press the release lever 1 upward and turn the
protection guard 12 to the required position.
Adjust the protection guard 12 in such a
manner that sparking is prevented in the di-
rection of the operator.
The protection guard 12 may be turned only
upon actuation of the release lever 1! Oth-
erwise the power tool may not continue to
be used under any circumstances and must
be taken to an after-sales service agent.
Note: The encoding keys on the protection
guard 12 ensure that only a protection guard
that fits the machine type can be mounted.
1 609 929 X20 | (28.7.10)
Protection Guard for Cutting
For cutting with bonded abrasives, always
use the protection guard for cutting 14.
Provide for sufficient dust extraction when
cutting stone.
The protection guard for cutting 14 is mounted
in the same manner as the protection guard for
grinding 12.
Cutting Guide with Dust Extraction Protection
Guard
The cutting guide with dust extraction protec-
tion guard 21 is mounted in the same manner as
the protection guard for grinding 12.
Extraction Hood for Sanding
The extraction hood 7 can be used for low-dust
sanding of paint, varnish and plastics in con-
junction with the carbide grinding head 9 or the
rubber sanding plate 17 with a sanding sheet
18. The extraction hood 7 is not suitable for
working metals.
A suitable Bosch vacuum cleaner can be con-
nected to the extraction hood 7.
The extraction hood 7 is mounted in the same
manner as the protection guard 12. The brush
collar is exchangeable.
Auxiliary Handle
Operate your machine only with the auxilia-
ry handle 5.
Screw the auxiliary handle 5 on the right or left
of the machine head depending on the working
method.
Hand Guard
For operations with the rubber sanding
plate 17 or with the cup brush/wheel brush/
flap disc, always mount the hand guard 16.
The hand guard 16 is fastened with the auxiliary
handle 5.
Bosch Power Tools