Limb A Tree; Buck A Log - GreenWorks 1403402 Manual Del Operador

Sierra telescópica/motosierra
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

EN
The level notching cut helps prevent pinching of
the saw chain or the guide bar when you make the
second notch.
2. Make the felling cut no less than 50 mm and higher
than the level notching cut. Make sure that this cut
a) Is parallel to the level notching cut.
b) Keeps sufficient wood to become a hinge (29)
which prevents the tree from twisting and felling
in the wrong direction.
When the felling cut (28) gets near the hinge (29),
the tree falls. Stop the felling cut if the tree
Does not fall in the correct direction or
Moves backwards, causing the cutting bar and
chain to become stuck in the cut.
3. Use felling wedge to open the cut and let the tree
fall in the correct direction.
4. When the tree starts to fall,
a) Remove the chainsaw from the cut.
b) Stop the machine.
c) Put the machine down.
d) Move away from the tree via the escape path
(25). Always keep watching the tree to see it's
direction of fall, be careful with overhead
branches and your footing.

15.5 LIMB A TREE

30
Limbing is the removal of the branches from a fallen
tree.
1. Keep the larger lower branches to hold the log off
the ground (31).
2. Remove the small limbs (30) in one cut.
3. Limb the branches with tension from the bottom to
top.
4. Keep the larger lower branches as a support until
the log is limbed.

15.6 BUCK A LOG

To buck is to cut a log into lengths.
Do not let the chain saw touch the ground.
CAUTION
31
CAUTION
English
It is important to make sure your footing is secure and
your weight is evenly distributed. If possible, lift the log
and hold it with branches, logs or chock. Obey the
instructions below:
32
When the log is held along the full length (32), cut it
from the top (33).
When the log is held on one end (34),
1. Cut the first time 1/3 of the diameter from the bottom
(35).
2. Cut the second time from the top (36) to complete
the bucking.
37
When the log is held on two ends (37),
1. Cut the first time 1/3 of the diameter from the top
(36).
2. Cut the second time lower 2/3 from the bottom to
complete the bucking (35).
12
33
36
35
34
36
35

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Psa803

Tabla de contenido