Cherubini PLUG&PLAY SHORT RX Instrucciones página 38

DELETING THE LIMIT SWITCH POSITIONS
During operation, the motor automatically acquires the limit switch positions. In the event
that the length or position of the limit switches need to be changed, the positions already
acquired by the control unit will need to be deleted.
B + C
+
B C
At the end of the sequence, the motor is ready to automatically acquire the new limit
switch positions.
ATTENTION! This operation deletes all the memorized middle positions.
SETTING OF ADDITIONAL REMOTE CONTROLS
Up to 15 remote controls can be set.
Tn: Already programmed remote control
Tx: Additional remote control
+
A B
A
+ B
Tn
REMOTE CONTROL MEMORY CLEARING
It is possible to delete singly all the memorized remote controls. When the last one is
deleted the motor initial condition is restored. The same applies to the single channels
of a multichannel remote control: just select the channel to cancel before performing the
sequence.
Tn: Remote control to be cleared
+
A B
Tn
B + C
+
B C
B
Tn
A
Tn
38
B + C
+
B C
4 sec
B
Tx (2 sec)
B
Tn (2 sec)