Cherubini PLUG&PLAY SHORT RX Instrucciones página 40

SHORT-TERM SETTING OF A REMOTE CONTROL AND SETTING
THE ROTATION DIRECTION OF THE MOTOR
This function makes it possible to store a remote control temporarily, for example, with
the purpose of setting the limit switches during assembly in the factory. A later final
saving of the remote control will be possible using the appropriate command sequence
(see: "SETTING THE FIRST REMOTE CONTROL"). The operations described below can be
carried out only when the motor is just come out of the factory or after a full memory
clearing (see: "FULL MEMORY CLEARING"). The motor makes the following operations
possible only within the time limits described in order to make sure that the short-term
setting is used only in the installation or factory setting phase and not during daily
use. Power up the motor, make sure that no other motor having an empty memory are
powered up in the same operating range.
Within 30 seconds after start, press the B and C buttons simultaneously until the
motor gives a confirmation signal.
T1: First remote control to be set
After the last confirmation movement, the motor starts a series of UP and DOWN
movements: the first lasts 2 seconds, the next ones go to max 10 seconds.
To properly associate the UP and DOWN buttons, press the button corresponding to the
motor movement for one second as indicated below:
?
The remote control will remain stored for 5 minutes, while the motor is powered
up. After 5 minutes or when the motor has its power cut off, the remote control will be
SPECIAL FUNCTIONS
+
B C
+
B C
T1
A
C
T1 (1 sec)
cancelled.
40
The motor stops: the
UP and DOWN buttons
are now properly
associated.