VALBERG FBI 14S40 B KAD929C Instrucciones De Uso página 19

B
How to connect the safety supply hose
1. Pull the safety supply hoses out from storage compartment located at rear of dishwasher.
2. Tighten the screws of the safety supply hose to the faucet with thread 3/4inch.
3. Turn the water fully on before starting the dishwasher.
How to disconnect the safety supply hose
1. Turn off the water.
2. Unscrew the safety supply hose from the faucet.
Connection of drain hoses
Insert the drain hose into a drain pipe with a minimum diameter of 4 cm, or let it run into
the sink, making sure to avoid bending or crimping it. The height of drain pipe must be less
than 1000 mm. The free end of the hose must not be immersed in water to avoid the back
flow of it.
WARNING
Please securely fix the drain hose in either position
position
B
Back of dishwasher
Mains Cable
Using the appliance
Drain hose
Water Inlet
Drain Pipe
12
Drain Pipe
A
B
EN
or
A
Counter
40 mm