Publicidad
Idiomas disponibles
Idiomas disponibles
can be relieved slowly.
Start the equipment min. 3 m
away from the fuel filling loca-
tion. Risk of fire or explosion in
case of non-observance
The filling volume
of the tank is 1200 ml.
Use only the fuel mix recommended
in the instructions. The fuel mix ages.
Therefore, do not use fuel mix that is
older than 3 months. In case of non-ob-
servance, the engine can be damaged
and the guarantee will be invalidated.
Avoid direct skin contact with
petrol and the inhalation of
petrol fumes. Health hazard!
erated exclusively with a mix of petrol and
two-stroke engine oil in the ratio 40:1.
Table of fuel mixtures:
Petrol
1,00 litres
3,00 litres
5,00 litres
Mixing
•
Use quality unleaded petrol with an oc-
tane rating of at least 90.
•
For optimal performance, use oil for air-
cooled two-stroke engines.
1. Mix petrol and oil in the fuel mixing bot-
tle (26). Use the scale on the container.
2.
First pour petrol into the
OIL
fuel mixing bottle (26) up
PETROL
to the line marked "PET-
The equipment is fitted
with a two-stroke en-
gine and therefore op-
Two-stroke oil
25 ml
75 ml
125 ml
40 parts of petrol
+ 1 part of oil
ROL".
Then pour in oil until you reach the sec-
ond mark ("OIL") on the scale at the
top right.
Close the container and shake it.
3. Remove the filler cap (39) and fill the
fuel mixture into the petrol tank (7).
Wipe spilled fuel from around the filler
opening and replace the filler cap.
Putting on the shoulder
strap
Always wear the carrying har-
ness when working with the
device. Always turn the device
off before taking off the carry-
ing harness. Risk of accidents.
The carrying harness is
equipped with a quick-release
device.
Opening the lock (40) re-
leases the device quickly from
the harness in a dangerous
situation.
1. Put on the carrying harness (27).
2. Adjust the strap so the spring clip is
around 10 cm below the hip.
3. Fix the spring clip onto the lifting ring
(9) on the shaft tube of the equipment.
Unhook the device before starting the
engine and fasten it to the carrying
harness once the engine is running.
Place the protective body (28) on
your hip between your body and
the device.
Starting the Engine
Start the engine at least three
metres from the filling location
GB
MT
43
Publicidad
