Safety Warnings For Submersible Pumps - Truper BOS-1SM Instrucciones De Uso

Safety Warnings for
Submersible Pumps
• Submersible pumps are designed for domestic and
garden use. Mostly used to drain flooding, liquids transfer,
to drain containers, pump out water from wells or mines,
drain boats and yachts, as well as oxygenating water and
water circulation for short periods of time.
• The pumps are totally submersible (waterproof sealed)
and can be used up to 23 ft deep inside the water.
CAUTION
• Liquids that can be pumped are: clean
liquids or slightly contaminated water and soapy waters with
suspended particles up to 1-3/8". Do not operate the pump
in waters with larger particles to prevent clogging.
WARNING • Do not pump corrosive, slightly
combustible or explosive substances (for example, gasoline,
petroleum, nitrate thinner), grease, oil, salt and sewer water.
• Liquids temperature shall no exceed 95° F, or cold with
the possibility of ice formations.
CAUTION • The pumps are not designed for
continuous operation (for example, continuous operation
operations). The useful life of the pump shortens with
regards to use.
• Since the pump can go ON and OFF
WARNING
automatically, do not insert your hands or other objects
when connected to the power supply.
WARNING
• Neither the plug or an eventual
capacitor holder may be submerged. Do not use the power
cable to lift or carry the pump.
• Do not use the pump inside a pond or
WARNING
swimming pool or other waters with access to people or
animals while it is running. It is not allowed to use the
device when people or animals are in the danger zones.
• In case there is risk of flooding, connect
CAUTION
the cables in a place protected against flooding.
CAUTION • Avoids running the pump dry.
CAUTION • Due to safety reasons, the submersible
pump shall always be operated with a safety circuit
interrupter (Switch F1) weighted with short circuit current
of ≤ 30 mA. The use ponds and fountains is allowed only
if operated through a safety circuit interrupter. As an
additional safety measure, use a ground fault
interrupter or another safety interrupter.
• Pumps used in swimming pools and garden ponds and
that are equipped with a sturdy power cable must be
connected through an isolated converter. It shall not
exceed the voltage indicated in the nameplate.
• Use care and make the connections in a dry place
protected from flooding.
• Protect the socket and power cable from heat, oils and
sharp edges.
• Check the voltage line. Data in the NOM (Mexican
Official Standard) in the equipment shall be the same to
those in the power source.
• Always verify the pump before using it (Especially the
power cable and the socket). Never use a damaged pump.
Go to a
repair.
• Before using, clear the outlet line. Observe the maximum
height of supply.
• To disconnect the power cable, pull the socket and not
the cable.
Authorized Service Center to
ENGLISH 5