Pump Location; Start Up - Truper BOS-1SM Instrucciones De Uso

Installation

Pump Location

• The pump shall be in a stable position (especially for
automatic operation), inside the water to be pumped.
• Regarding the automatic operation, any obstacle shall be
removed so that the float can move freely.
• Double check the openings in the suction base are no
partially or totally obstructed. Setting the pump onto a
brick is recommended.
• Never use the power cable or the float switch to carry or
hang the pump. When submersing the pump in a well or
mine use the plastic rope included. Tie it to the handle for
transportation (C).

Start Up

Float Switch
• The float switch turns the pump ON and OFF
automatically depending of the height in the water level.
When the float is approximately at 21" height, the pumps
turns ON. When lowering to a 3,9" height approximately,
the pump turns OFF.
• To control the float switch manually, and to prevent the
pump to turn OFF automatically, secure the switch cable
in the cable lock (D) so that the float will not go down
turning OFF the pump.
CAUTION • When controlling the float switch
manually, do not leave the pump running unsupervised to
prevent it will operate dry.
C
D
ENGLISH
7