Important; Warranty - Everbilt LTS250A Instrucciones De Uso

Safety Information (continued)
WARNING: Ensure that the electrical circuit to the pump
is protected by a 15 Amp fuse or circuit breaker.
CAUTION: Do not lift the pump by the power cord.
CAUTION: Know the pump and its applications,
limitations, and potential hazards.
CAUTION: Follow all safety standards and all local
electrical codes.
IMPORTANT: The motor of this pump has a thermal
protector that will trip if the motor becomes too hot. The
protector will reset itself once the motor cools down and an
acceptable temperature has been reached. The pump may
start unexpectedly if it is plugged in.

Warranty

The manufacturer warrants the products to be free from defects in materials and workmanship for a period of one year from date of
purchase. This warranty applies only to the original consumer purchaser and only to products used in normal use and service. If within one
year this product is found upon examination by the manufacturer to be defective in materials or workmanship, the manufacturer's only
obligation, and your exclusive remedy, is the repair or replacement of the product at the manufacturer's discretion, provided that the
product has not been damaged through misuse, abuse, accident, modifications, alterations, neglect or mishandling. Your original receipt of
purchase is required to determine warranty eligibility.
The purchaser must pay all labor and shipping charges necessary to replace the product covered by this warranty.
This Limited Warranty does not cover products which have been damaged as a result of an accident, misuse, abuse, negligence, alteration,
improper installation or maintenance, or failure to operate in accordance with the instructions supplied with the products, or operational
failures caused by corrosion, rust, or other foreign materials in the system.
Requests for service under this warranty shall be made by returning the defective product to the manufacturer as soon as possible after the
discovery of any alleged defect. The manufacturer will subsequently take corrective action as promptly as reasonably possible.
The manufacturer does not warrant and especially disclaims any warranty, whether express or implied, of fitness for a particular purpose,
other than the warranty contained herein. This is the exclusive remedy and any liability for any and all indirect or consequential damages or
expenses whatsoever is excluded.
Some states do not allow the exclusion or limitation of incidental or consequential damages or limitations on how long an implied warranty
lasts, so the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights and you may also have other
rights which vary from state to state.
For Professional Technical Support call 1-844-241-5521 or visit WWW.HOMEDEPOT.COM.
For warranty registration please go to www.gppumpsus.com
IMPORTANT: Ensure the electrical power source is
adequate for the requirements of the pump.
IMPORTANT: This pump is made of high-strength,
corrosion-resistant materials. It will provide trouble-free
service for a long time when properly installed,
maintained, and used. However, inadequate electrical
power to the pump, dirt, or debris may cause the pump to
fail. Please carefully read the manual and follow the
instructions regarding common pump problems and
remedies.
NOTE: This pump does not require a connection to a main
stack vent, per the National Standard Plumbing Code
(NSPC) 2003 Section 11.7.9.
3 For Professional Technical Support call 1-844-241-5521