AIMA BIG SUR Manual Del Usuario página 23

Adjust the height and angle of the
handlebars to the desired position,
then use a 3mm hex wrench to
tighten the screws to secure it to
the frame. Note: The 4 screws
should be tightened in the order
indicated by the arrows in the
picture.
Step Seven
Use a 3mm hex wrench to tighten
the display clamp to the desired
angle.
Step Eight
Pedal Installation.
Install the pedals with a pedal wrench. The pedal with the "R" (below 1)
mark at the end of the pedal axle is the right pedal. The right pedal goes
on the crank on the right side of the bike (the crank with the drive chain
gear, which is the same side as the right side of the cyclist when riding).
The right pedal
(1) has threads that turn clockwise. Apply lubricating grease to the
threads, and slowly and carefully screw the right pedal onto the crank
on the right side of the bike by hand.
21