Publicidad
Idiomas disponibles
Idiomas disponibles
Follow the steps below to charge your bicycle:
Ensure the power is turned off.
1
2
Remove the rubber cap on the charging port.
3
Plug the charger into the battery's charging port before plugging the charger into the
power outlet. Leave the battery on the bike or take it off, place the charger in a flat and
safe place, and connect the DC output plug from the charger (cylindrical connector) to
the charging port on the side of the battery.
4
Plug the charger into the power outlet. Connect the charger input plug (110/240-volt
plug) to the power outlet. Charging should start, and the LED charging status light on
the charger will show a steady red.
5
Unplug the charger from the charging port. When fully charged, a charging indicator
light will turn green. First, unplug the charger from the wall outlet, then unplug the
charger output plug from the battery charging port.
Battery indicator light: Blue: 80%-100% Green: 33%-80% Red: 0%-33%.
6
Please make sure to charge the battery at a temperature between
32°F-104°F (0°C-40°C) and ensure that the battery and charger are
undamaged before starting to charge. If you notice any abnormalities
while charging. Please stop charging and using the bike and contact
AIMA bike product support for help.
1
The battery should be fully charged when the new vehicle is used for the first time.
2
After each use of the vehicle, it should be charged as soon as possible. This is beneficial
for prolonging the service life of the battery.
3
During the use of the battery, over-discharge, under-charging, and overcharging are
prohibited to prevent damage to the battery and shorten the service life of the battery.
4
The battery should not be near open flames or high-temperature heat sources. Exposure
to the sun is strictly prohibited in high-temperature seasons to avoid damaging the
Charger Use and Maintenance
Battery Use and Maintenance
36
Publicidad
