Kinderkraft NESTE GROW Manual De Uso página 41

3. Extra bed feature
To connect the crib to the parents' bed, unfasten safety devices located by the locks on the side
of the crib (fig. M). Undo the zippers on both sides (fig. N). Move the lever and pull out the tube
of side panel (fig. O). Repeat on the other side. Take the side panel on the outside of a crib and
take out the tube from the inside (fig. P). Adjust height of the crib to the parents' bed. (fig. R).
Fasten the buckles of the fixing straps by the crib (fig. S). Weave straps through the entire crib
or only through the side bar (fig. T) and make adjustments, so the crib fits tightly to the parents'
mattress. Connect the buckles on the straps back together (fig. U). Coil up loose parts of the
fixing straps (10) under the crib. To bring the crib as close as possible to the base of the parent's
bed, adjust the length of the legs. Move button A to the side, simultaneously pressing button B
(fig. W). Move legs of the crib towards parents' bed at the same time. ATTENTION! Make sure,
that the straps are correctly adjusted, and the crib fits tightly to the parents' mattress (fig. R).
4. Crib assembly >90cm for older children (fig. AF)
Pull the mattress (7) and the bottom board (6) out of the crib. Detach the straps if they were
previously attached in the convertible crib mode. If the side panel was lowered, put it back in
place, securing it correctly. Adjust the height of the crib to level 5 (see section 5). Disconnect
the supports - hold the metal latch and pull the side support (5) outwards. Slide the side support
out of the fabric of the crib cover. Put clip or safety pin in the slider located inside the bed, then
undo the zipper around line connecting side material and the bottom material. (fig. V).
Attention - once you have finished, the safety pin or clip should be absolutely removed from
the crib. There is an extension of the bottom board (8) in a pocket underneath the bottom of a
crib - take it out. (fig. Z). Undo the zipper located on the outside of the crib, that connects side
material with bottom material. Use a screwdriver (12) to loosen the bolts locking butterfly
levers, which are located on both legs of the crib (fig. X).
To lower the base of the crib, lift it up slightly and release the butterfly levers. Then lower the
bottom of the crib slowly. Then secure butterfly levers by tightening the bolts. Place the fabric
strips from underneath the bottom of the bed along the legs inside the pockets on the side of
the cover and fasten with velcro (fig. Z). Connect extension of the bottom board (8) with the
bottom board of the crib (fig. AA) after undoing the covering material. Take the sheet off the
mattress and connect the mattress extension (9) to the mattress with velcro (fig. AB). Put the
sheet back on. Put the finished elements inside the crib. First clip the plastic handles on the
bottom holding center support, then add the mattress.
5. Height adjustment (not applicable for a crib >90 cm)
The crib has 5-step height adjustment. To set the desired height, move button A while
simultaneously pressing button B, and set the frame to the desired height (fig. AC). The crib
has a tiltable bottom. Maximum level difference is two.
6. Wheels locking
The crib has two wheels, making it easy to move it and fit it to the parents' bed. To lock them,
push down on the locking lever. To unlock the wheels, pull the lever up (fig. AD).
41