Radio Operation; Band Button; Tune/Seek Up/Down Buttons; Aps Button - KDX R-091 Manual Del Usuario

3

RADIO OPERATION

3.1

BAND BUTTON

In the radio mode, press BAND button on the front panel or remote
control to select your desired radio band of FM1, FM2, FM3, AM1 and
AM2.
Press and hold BAND button on the front panel to pop up RADIO INTERFACE 2
as right. Then use VOL knob and SEL button to select and confirm your
selection.

3.2 TUNE/SEEK UP/DOWN BUTTONS

Press and hold the UP/DN button to automatically search up/down for a
available station from current frequency.
Briefly press the UP/DN button to manually search up or down for your
desired frequency step by step.

3.3 APS BUTTON

When press and hold the APS button, the radio searches from the lowest frequency and checks the signal
strength level until 1 cycle search is finished. And the 6 strongest stations are stored to the corresponding
preset number memory bank. The AS operation is implemented in each bank of the selected band. When
the AS operation is finished, the radio executes the preset scan. After preset scanning for a cycle, it will
stop scanning and to broadcast the No.1 station of FM or AM. (It can store 3x6 stations for FM and 2x6
stations for AM in all)
When press the APS button briefly on the front panel or the remote control, the radio searches for each
preset station from the M1. When the field strength level is more than the threshold level of the stop level,
the radio holds at that preset number for few seconds with releasing mute, and then searches again. After
finishing a circle of searching, it will stop searching on the M1.
NOTE: In FM band, FM1,FM2,FM3 is checked one at a time.
In AM band, Am1, Am2 is checked one at a time.

3.4 PRESET STATION [ 1-6 ] BUTTONS

To memorize the current frequency on the current band, press and hold any one of the six Number
buttons (1-6) .
To recall the memory station on the current band, press one of the Number buttons [1-6] .

3.5 STEREO/MONO BUTTON

Press the ST button on the remote control to select the STEREO or MONO sound mode for FM band.

3.6 LOC BUTTON

When the signal of the distance radio station is very weak and the receiving effect is bad during tuning,
check whether there is the word LOC on LCD. If there is the word LOC on LCD, press this button to turn off
the LOC function, then tune again for the distance radio station.
When the signal from the local radio station is too strong, this could lead to interference. Press this button
to turn on the LOC function, and the LOC icon will be lit up on the LCD. Re-tune for the local station
required.

3.7 PTY (PROGRAM TYPE) BUTTON

Press the PTY button briefly to turn on PTY mode, then press the + or – button on the remote control or to
select one of PTY programs as follows:
- 9 -
RADIO INTERFACE 1
RADIO INTERFACE 1