Playback With Speed; Playback With Low Speed; Playback With Still Frame; Playback Repeatedly - KDX R-091 Manual Del Usuario

During JPEG playback press one of the direction ( / / / ) buttons to change the angle of viewing picture
that is displaying as follows:
>: 90 deg cw;
^:UP<-->DOWN;

4.7 PLAYBACK WITH SPEED

During normal playback press and hold the UP/DN button on the front panel or the
the remote control continuously to fast forward or backward at the following speeds: x2, x4, x8, x20,
normal.
During speed playback, press the PLAY button to resume normal playback.

4.8 PLAYBACK WITH LOW SPEED

During playback press the SLOW FWD button to execute the Slow Forward function.
With each consecutive pressing of the SLOW FWD button, the playback speed decreases. The speed levels
in Slow Forward as follows: x1/2, x1/3, x1/4, x1/5, x1/6, x1/7, normal.
During slow forward, press the PLAY button to resume normal playback.
NOTE: The function is only for video.

4.9 PLAYBACK WITH STILL FRAME

During video file playback press the STEP button consecutively to display the still frame forward with step
by step. Press the PLAY button to resume normal playback.

4.10 PLAYBACK REPEATEDLY

4.10.1 ONE/ALL REPEAT

During playback press the RPT button to select REP ONE, REP DIR, REP ALL or OFF.

4.10.2 A-B REPEAT

Press the A-B button if you want to repeat a specific segment on a song or a movie that you define:
1 Press the A-B button at a point (A) where you want it to be the start point of the repeat segment.
Press the A-B button again at a point (B) where you want it to be the terminal point of the repeat
segment. Then it will play the segment repeatedly.
2 To cancel the A-B repeat mode and resume normal playback, press the A-B button for the third time.
NOTE: During playback points A and B must be within the same chapter.
4.11 PLAYBACK IN SCAN MODEL
During playback press the INT button to play the previous 15 seconds part of each chapter. Press the INT
button again to resume normal playback.

4.12 PLAYBACK FROM A SPECIFIED CHAPTER/TRACK

During playback press the SEARCH button to display an interface and highlight the track item, then use the
number buttons to input the serial number of the track; finally press the OK or PLAY button to play the
selected track.

4.13 PLAYBACK IN RANDOM

During playback press the RDM button to switch between RANDOM (ON)/ RANDOM OFF. When in
RANDOM(ON) mode, it will play in random. (This function is only for MP3/WMA files)
<: 90deg ccw;
v: LEFT<-->RIGHT
- 12 -
/ button on