Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
english
W
The
icon will appear on the screen for two
seconds. When the icon disappears from the dis-
play, the program data has been successfully
transmitted.
R
Note: Press
made any changes to the programming
data. This will synchronize the time
between the two devices.
On-off Mode/System Override
The Field Transmitter's On-off function allows you to
completely suspend and override all currently set
programming in the Control Module, without
changing or losing this programming for future use.
The Control Module's default mode is always ON,
allowing programmed watering to take place. You
can prevent watering, however, by activating the On-
off Mode, thereby switching the Control Module's
default mode to OFF.
Activating a Control Module's On-off Mode
To activate the On-off Mode (or turn the Control
Module's default mode to OFF):
B
1. Press
on the Field Transmitter repeatedly
until the
• If the On-off Mode is deactivated, you will see the
icon, indicating that the Control
Module will water according to current program-
ming.
• If the On-off Mode is activated, you will see the
icon, indicating that all Control
Module programs have been overridden and no
watering will take place.
even if you have not
icon is displayed.
16
TBOS
™
Field Transmitter
2. If the
icon is displayed, press
The Field Transmitter sends the irrigation OFF
command to the Control Module. An X will
appear on the sprinkler icon
Deactivating a Control Module's On-off Mode
To deactivate the On-off Mode (or turn the Control
Module's default mode on):
B
1. Press
on the Field Transmitter repeatedly
until the
icon is displayed.
• If the On-off Mode is deactivated, you will see the
icon, indicating that the Control
Module will water according to current program-
ming.
• If the On-off Mode is activated, you will see the
icon, indicating that all Control
Module programs have been overridden and no
watering will take place.
2. If the
icon is displayed, press
The Field Transmitter sends the irrigation ON
command to the Control Module. The X on the
sprinkler icon disappears
Verifying the On-off Mode
To check the Control Module's On-off status:
1. Plug the Field Transmitter's optical connector
into the Control Module's optical connector.
2. If the Field Transmitter's display is blank,
B
press
.
T
3. Press
on the Field Transmitter to receive
(upload) the program data stored in the Control
Module.
B
4. Press
on the Field Transmitter repeatedly
until the
icon is displayed.
17
english
P
.
.
O
.
.
(continued)
Publicidad
Tabla de contenido
Solución de problemas
