Rain Bird TBOS Manual De Instrucciones página 8

english
5. Repeat steps 3 and 4 until you have set all of the
start times you desire (up to eight per program)
for the program.
6. If you would like to set start times for additional
A
programs, press
is displayed. Then repeat steps 3 and 4.
7. When you have finished setting the start times,
B
press to move to the
Watering Time Length display.
Deleting a start time
To delete a start time:
B
1. Press to advance to the
A
2. Press to change to the appropriate program.
C
3. Press to scroll through the start times until
the start time you want to delete is displayed.
(The start times will be in chronological order).
O P
4. Press or
(--:--) appears in the display. The blank position
is located between 11:59 and 12:00 (AM or PM).
C
5. Press to scroll through the remaining start
times and confirm the deletion.
Setting the run time per station
You can set the run time for each station from 0 to 12
hours (in one minute increments). All One Station
Control Modules must be programmed on station 1.
Multi-station Control Modules (Two, Four, or Six
Station) must be programmed starting on station 1.
For example, on a Four Station Control Module, pro-
gramming would start on station 1, then station 2, 3
and 4.
Note: Each station may be assigned to
only one program (A, B or C)! The sta-
tion will only respond to the start times
and days on for this program.
until the program you desire
H
icon, Setting the
G
icon.
until the blank position
12
TBOS ™
Field Transmitter
Note: The time display is represented in
hours and minutes. The first two place-
holders are for hours; the second two
placeholders are for minutes.
To set the run time:
H
1. Make certain the icon is
visible on the display. If it is
B
not, press repeatedly
to cycle through the menu
system and display the
icon.
2. The station number appears to the left of the run
C
time. Use to select the station.
A
3. Press repeatedly until the program you desire
(A, B, or C) flashes in the display (to the right of
the run time). Each station must be assigned to a
program (A, B, or C).
O P
4. Use and to set the station run time.
C
5. Press to move to the next station.
6. Repeat steps 3 through 5 until you have set all of
the station run times.
Note: If there is an overlap on the same
station, the second run time will not
take place.
7. When you have finished setting the run times,
you may review the run times by pressing
Erasing Field Transmitter programming data
To erase all program data in the Field Transmitter
(except the current time and day):
O P
Press and hold and
least three seconds.
All programming data are erased.
13
english
H
C
.
simultaneously for at