Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Jandy
Smart Sync
®
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction, may
cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
interference by one or more of the following measures:
–
Reorient or relocate the receiving antenna.
–
Increase the separation between the equipment and receiver.
–
Connect the equipment into an outlet on circuit different from
that to which the receiver is connected.
–
Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Page 2
LED Adapter | Installation & Operation Manual
®
CAUTION
Jandy
Smart Sync
LED Adapter | Installation & Operation Manual
®
®
Table of Contents
Section 1. Important Safety Instructions ..................................... 4
Section 2. Installation .................................................................... 5
2.1 Select Series .............................................................................. 5
2.2 Mount the Smart Sync LED Adapter .......................................... 6
2.3 Attach Wiring .............................................................................. 7
2.4 Adjust Brightness ..................................................................... 10
Section 3. Operation .................................................................... 10
3.1 J-Series (Factory Default) ......................................................... 10
3.2 H-Series ................................................................................... 12
3.3 P-Series .................................................................................... 14
ENGLISH
Page 3
Publicidad
