Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Jandy
Smart Sync
®
2.4
Adjust Brightness
WARNING
Turn off all power to the Smart Sync LED Adapter before opening enclosure and adjusting
brightness.
1.
Turn off all power to the Smart Sync LED Adapter before opening
enclosure.
2.
Open the enclosure door.
3.
Adjust brightness by rotating the dimmer dial. There are eight
brightness settings from 0–7, with 0 being the brightest setting.
NOTE: Follow the same steps when adjusting brightness after initial
installation.
Section 3. Operation
ATTENTION
Incorrect wire connections will affect color sequencing. For problems with color sequence
and/or synchronization, check wire connection(s) and wire color coding.
3.1
J-Series (Factory Default)
1.
Turn the light ON.
2.
Turn the light OFF and ON within three seconds repeatedly until
you reach the desired color or show. See Table 1 for the color
sequence.
NOTE: When the light is OFF for more than seven seconds, it will remain on
the last active color or show.
3.1.1 Reset J-Series Lights
To reset the light to the beginning of the color sequence (Alpine White):
3.
Turn the light OFF.
4.
Wait four to six seconds.
5.
Turn the light ON.
Page 10
LED Adapter | Installation & Operation Manual
®
Jandy
Smart Sync
LED Adapter | Installation & Operation Manual
®
®
Table 1. J-Series Colors and Shows Sequence
Sequence
Order
1
Alpine White
2
Sky Blue (primary blue)
3
Cobalt Blue (dark blue)
4
Caribbean Blue (light blue)
5
Spring Green (light green)
6
Emerald Green (primary green)
7
Emerald Rose (warm yellow)
8
Magenta
9
Violet
10
Slow Color Splash (slow fading color show)
11
Fast Color Splash (fast fading color show)
12
America the Beautiful (red/white/blue show)
13
Fat Tuesday (blue/pink/light green show)
14
Disco Tech (rapid exciting color show)
ENGLISH
Color/Show
Page 11
Publicidad
