Olimpia splendid CALDO TRENDY Instrucciones Para El Uso Y El Mantenimiento página 29

3.3 - USE OF THE APPLIANCE
3.3.a - Preliminary operations
• After installing the appliance as described in the previous para-
graphs, make sure the mains data correspond to what is indicated
on the appliance nameplate.
• Insert the plug into the power socket and position the switch (9)
to "I".
3.4 - INSTRUCTIONS FOR OPERATION
3.4.a - Switching on
Make sure the switch is set to "I" (ON) (6); press the ON/OFF key (SW1) or (T1): the
appliance emits a "Beep" and switches on.
Press the ON/OFF key (SW1) or (T1) again to switch off the appliance.
After the appliance has been switched off, the fan will continue to work for
approximately 1 minute to cool down the components, it will stop automatically.
Set the switch to "0" (ON) (6) to switch off the appliance.
3.4.b - "HIGH" mode
Press the Mode key (SW2) or (T2) until the Led (S1) switches on.
Press the keys (SW3 - SW4) or (T3 - T4) to increase or decrease the desired tem-
perature.
When the room reaches a comfortable temperature, reduce temperature until the
thermostat emits a "Click". The heater switches on and off cyclically to maintain the
set temperature.
Temperature is read by a thermostat located in the appliance, install a ther-
mometer in another part of the room for a more accurate reading.
3.4.c - "LOW" mode
Press the Mode key (SW2) or (T2) until the Led (S2) switches on.
Press the keys (SW3 - SW4) or (T3 - T4) to increase or decrease the desired tem-
perature.
When the room reaches a comfortable temperature, reduce temperature until the
thermostat emits a "Click". The heater switches on and off cyclically to maintain the
set temperature.
CALDO TRENDY - CALDO TRENDY T EN - 11