Olimpia splendid CALDO TRENDY Instrucciones Para El Uso Y El Mantenimiento página 31

3.4.f - "SWING" mode
Press key (SW6) or (T6) until the LED (S4) switches on and the appliance body (1)
starts to rotate in alternate direction (fig.7).
Press key (SW6) or (T6) again: the function switches off and the appliance stops in
the chosen position.
4 - OVERHEAT PROTECTION
• This heater is protected with overheat protection that switches off the appliance
automatically in case of severe overheating. In this case:
- unplug the appliance;
- wait about 30 minutes for it to cool;
- remove any possible cause of overheating, eg. something covering the heater;
- check for damage to the appliance, the cord and the plug.
• If there is no damage:
- plug the unit back in;
- switch it on as described above.
If the heater still does not turn on, please contact Customer Service for assistance.
5 - SAFETY CONTROL (anti-overturning switch)
• If the appliance falls or overturns, the anti-overturning switch is activated and
automatically turns it off.
• It is necessary to place the appliance in vertical position to resume normal
operation.
6 - MAINTENANCE AND CLEANING
Before carrying out any cleaning or mainte-
nance operation on the appliance, switch it
off by setting the ON/OFF switch (9) to "O".
Disconnect the plug from the socket and wait
for the fan to stop.
• Use a dry cloth to clean the appliance.
• If the appliance is very dirty, it is possible to use a cloth dampened with warm water
(max 50°C) and a mild detergent to clean its external parts. Dry with a dry cloth.
• Use a vacuum cleaner to remove dust from the air inlet/outlet grids (fig. 9).
CALDO TRENDY - CALDO TRENDY T EN - 13